Step 1: Firewall rules creation failed

Important! The information provided in this section is for general Troubleshooting guidance only. The information is provided on "AS IS" basis, with no guarantee of completeness, accuracy or timeliness, and without warranty or representations of any kind, expressed or implied. In no event will CloudEndure and/or its subsidiaries and/or their employees or service providers be liable to you or anyone else for any decision made or action taken in reliance on the information provided above or for any direct, indirect, consequential, special or similar damages (including any kind of loss), even if advised of the possibility of such damages. CloudEndure is not responsible for the update, validation or support of troubleshooting information.

Possible causes for failure

1. Your credentials may not have enough permissions to manage required resources on the TargetThe location where the Replication Server will be located and where Target machines will be created (as a result of Test, Cutover or Recovery). cloud.
   To provide sufficient permissions:
• Change your credentials - either generate new credentials with the required permissions, or change the permissions of the existing credentials.
• If you generated new credentials, navigate to the Setup & Info> CREDENTIALS page, enter your new credentials, and save them.
2. The subnet you selected for launchingAfter the replication to the Staging area, launching is the process of setting up the Replication Servers, for Testing or Cutover and Recovery purposes. the Replication ServersThe CloudEndure Machine to which Staging Disks are attached and to which data is replicated; launched on the Target location. may no longer exists.

To select an appropriate subnet for the Replication ServersThe CloudEndure Machine to which Staging Disks are attached and to which data is replicated; launched on the Target location./Staging AreaA part of the Target location; includes the Replication Servers’ subnet, IPs, and the Replication Servers and their disks.:

1. Navigate to Setup & Info > REPLICATION SETTINGS.
2. From the Replication Servers section – Choose the subnet… drop-down list, select an existing subnet for the Replication ServersThe CloudEndure Machine to which Staging Disks are attached and to which data is replicated; launched on the Target location.:
   
3. Ensure that your IAM policy is correct.