Important! The information provided in this section is for general Troubleshooting guidance only. The information is provided on "AS IS" basis, with no guarantee of completeness, accuracy or timeliness, and without warranty or representations of any kind, expressed or implied. In no event will CloudEndure and/or its subsidiaries and/or their employees or service providers be liable to you or anyone else for any decision made or action taken in reliance on the information provided above or for any direct, indirect, consequential, special or similar damages (including any kind of loss), even if advised of the possibility of such damages. CloudEndure is not responsible for the update, validation or support of troubleshooting information.
Once disks are disconnected from a machineA physical or virtual computer., CloudEndure can no longer replicate them, so they are removed from the list of replicated disks. When they are re-connected, the CloudEndure AgentThe Agent is a software program that is installed on machines in the Source location that need to be migrated or replicated to the Target location. cannot know that these were the same disks that were disconnected and therefore does not add them automatically.
To add the disks after they are connected again, run the CloudEndure Agent InstallerInstalls the CloudEndure Agent. on the machineA physical or virtual computer.. Note that the returned disks will need be replicated from scratch.
©2020 COPYRIGHT CloudEndure - Terms of Service - Privacy Policy - AWS Vulnerability Reporting Guidelines - Report a Security Issue